*NC*=not connected, used as cable referenceįrom and you can download the OCD-commander, but it will not work with the wiggle.DHT-Walnut: JTAG Pin Out Connector Specifications for DHT-walnut-PPC405GP.

be careful about what you do: you could damage the PCB To add the J10 to the board suck or wick the solder out of the holes and solder it in, but be minded a common header has pins larger than holes, so. See How To build the JTAG Wiggle interface & add the JTAG connector at J10, Just in case you make a brick, you could fix the jam, using this procedure: JTAG Bootloader Installation

The OCD Commander software is supported under Windows 98/ME, NT, 2000, 2003, XP operating systems This debugger is not designed to be used to program flash devices connected to your target. You will be able to test the connection, memory access, modify memory and registers, run code and more using this product. The OCD Commander is macraigor's free debugger software, which allows you to connect to your supported target type chip via the On-Chip Debug port (BDM or JTAG) using a Macraigor hardware device.

5 OCD, Recovering a bricked board (download and use the recovery kit).

2.3 About the software for the jtag cable.

Download jtag pinout for free